We are excited to offer both a single batch panel and double batch panel for the Spike Nano System. The double batch panel allows the brewer to heat both the HLT and BK simultaneously. This can come in handy when brewing two batches in a row to save time, or to heat cleaning water in HLT while boiling. Both panel options will also be available in both 208v and 240v. 


Single Batch Panel

  • Both 208V/240V heating elements available depending on your need. Single Phase
  • Please specify voltage of your building so correct elements can be sent
  • 4 wire; hot, hot, neutral, ground
  • Full load amperage @208V = 75A
  • Full Load Amperage @240v = 65A
  • Single feed required


Double Batch Panel

  • Both 208V/240V heating elements available depending on your need. Single Phase
  • Please specify voltage of your building so correct elements can be sent
  • 4 wire; hot, hot, neutral, ground
  • Full load amperage @208V = 133A
  • Full Load Amperage @240v = 115A
  • Dual feed required

*All work should be done by a qualified electrician in accordance with local and national electrical codes

**208v Three Phase available


Cord Lengths

  • Electrical Panel to Junction Box - Length determined by your electrician, length may vary
  • Electrical Panel to Boil Kettle - 2 x 8 Foot Cords
  • Electrical Panel to Hot Liquor Tank - 2 x 15 Foot Cords


Installation Cost Estimator



Residential

Commercial

Material Cost

$12/ft

$18/ft

Labor Cost

$9/ft

$12/ft


*For double batch panel installs double both material cost and labor cost

**Calculated at $85/hr. labor rate and 50ft install

**These are budgetary estimates only. Actual install costs can vary.